Avalon Acoustics Sentinel manual

5.Carefully lift each upper speaker cabinet by the small overhang at the base, and place it directly on top of the lower speaker cabinet, with the set- up blocks between them. Then gently slide the upper cabinet slightly forward to expose the wiring tubes in the lower cabinet (See Figure 3.4).

6.Route the upper speaker cabinet wiring through the wiring tubes and out the bottom rear of the lower speaker cabinets, as shown in Figure 3.4.

Figure 3.4 – Placement of upper speaker cabinet atop lower speaker cabinet. The upper speaker cabinet is slid forward to allow for routing of the upper speaker cabinet wiring through the wiring tubes.

6.Once the wiring is routed through the wiring tubes, slide the upper speakers cabinets back, so that the couplers on the upper speaker cabinet are directly above the sockets on the lower speaker cabinet (see Figure 3.5). If necessary, gently adjust the upper speaker cabinet on the set-up blocks.

7.Remove the set-up blocks (refer to Figure 3.5): Lift the back side of the upper speaker cabinet slightly, freeing the rear set-up block. Remove the rear set-up block, and carefully lower the two rear Apex‘ Couplers into their respective receiving sockets. Then lift the front side of the upper speaker

19