Avanti BCAD680 instruction manual Problems with Your Beverage Center ?, Troubleshooting Guide

PROBLEMS WITH YOUR BEVERAGE CENTER ?

You can solve many common beverage center problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer.

TROUBLESHOOTING GUIDE

PROBLEM		POSSIBLE CAUSE
Appliance does not operate.	Not plugged in.
	The circuit breaker tripped or a blown fuse.
Appliance is not cold enough.	Check the temperature control setting.
	External environment may require a			cooler
	setting.
	The door is opened too often.
	The door is not closed completely.
	The door gasket does not seal properly.
Turns ON and OFF frequently.	The room temperature is hotter than normal.
	A large amount of contents has been added to
	the appliance.
	The door is opened too often.
	The door is not closed completely.
	The temperature control is not set correctly.
	The door gasket does not seal properly.
The light does not work.	Not plugged in.
	The circuit breaker tripped or a blown fuse.
	The	fluorescent tube	has burned out.
	The	ballast has burned out.
	Light switch is OFF.
Vibrations.	Check to assure that the appliance is level .
The appliance seems to make too much noise.	The rattling noise may come from the flow of the
	refrigerant, which is normal.
	As each cycle ends, you may hear gurgling
	sounds caused by the flow of refrigerant in your
	appliance.
	Contraction and expansion of the inside walls
	may cause popping and crackling noises.
	The appliance is not level.
The door will not close properly.	The appliance is not level.
	The door was reversed and not properly installed.
	The gasket is dirty.
	The shelves are out of position.

13