Avanti IMD250 Operating Your Ice Maker, Control Panel Description, Ice Size Selector D

OPERATING YOUR ICE MAKER

Control Panel Description

AADD WATER or Tank Empty Indicator

BICE BIN FULL Indicator

CCube Size Selection Indicator (Large / Small)

DCube Size Selector Button

EPower ON Indicator

FPower ON / OFF Button

Ice Size Selector (D)

ICE SIZE SELECTION of (S) Small or (L) Large.

The default cube size from the factory is set at SMALL.

Each time you press this button the cube size selection will change 1 size (Small or Large) in sequence.

The chosen mode shall stay as selected unless changed or there is a power failure.

For the most efficient operation when ambient temperature is below 15°C (59ºF) use the small cube size setting.

LED INDICATORS

ICE SIZE INDICATOR (C)

Cube size selection is shown (S) Small or (L) Large.

The indicator next to the selected cube size will be illuminated green.

ADD WATER INDICATOR (A).

The ice maker automatically checks the water level in the tank. If the water level is too low the indicator will illuminate in RED and will stop working automatically. Once you add water to the unit the indicator will turn off and will resume normal operation.

ICE FULL INDICATOR (RED) (B).

When the ice-bin is full, the indicator will illuminate in RED.

The indicator will remain lit even if the ice in the bin either melts away slowly or has been removed. The unit will stay in a “STANDBY” mode for approximately 6 hours. To restart the ice-making process push the “STOP” button, remove all of the ice from the ice-bin, wait for approximately 3 minutes and then press the “START” button. The ice-making process will return to normal mode.

10