Instructions below are for refrigerators with a solid top. If installing on refrigerator with a decorative (plastic) top skip to Step #4
2)Installation of the lower side of the Metal bracket to the Refrigerator:
Lay and center the Metal bracket on top of the refrigerator as close to the back as possible.
Using the four (4) existing holes on the bracket as a guide, mark the locations where the Self Tapping Screws are to be installed (C), (D), (E) and (F).
3)Affixing the Metal bracket to the refrigerator
Align the four (4) holes of the lower part of the metal bracket and attach the bracket using the (4) Self Tapping screws provided. See illustration #2.
Illustration # 2
4)Drilling four holes to the Refrigerator: For refrigerators with decorative (plastic) top
After marking the locations of the four (4) holes, remove the bracket from the top of the refrigerator and proceed drilling the four (4) holes with a ¼” drill bit into the rear portion of the top of the Refrigerator. Be careful not to drill too deep and risk damaging the sealed system tubing or liner. See illustration #3
Illustration # 3
2
