INSTALLATION INSTRUCTIONS
¾Installation of Your Appliance
Select a location for the appliance. The location should be in an open area on a flat counter where the plug will reach an outlet.
•When positioning the appliance, it should be set on a flat, steady surface.
•Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause the appliance failure.
•Keep the appliance away from hot air, steam or splashing liquids when choosing a place to locate it, otherwise, the unit’s operation may be adversely affected, causing it to break down.
•Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
•Plug the appliance into an exclusive properly installed grounded wall outlet. Any questions concerning power should be directed toward a certified electrician or an authorized Avanti Products service center.
•Do not place anything on the top of the oven.
•Keep the appliance at least 5 inches away from rear wall to ensure the proper ventilation.
¾Before Using Your Appliance
•Remove the exterior and interior packing.
•Check to be sure you have all of the following parts:
•1 Baking/Broiling Tray
•1 Pan Removal Tool
•1 Oven Rack
•1 Crumb Tray
•1 Instruction Manual
•Remove all the items inside your oven and clean the interior surface with lukewarm water using a soft cloth.
•Do not attempt to repair or replace any part of your oven unless it is specially recommended in this manual.
•This appliance requires 1440W and should be the only appliance operating on the same circuit.
¾Using Your Oven
NOTICE
Before you use this oven for the first time: The heating elements have a protective coating, which must be burned off before use. To do this, open the oven door and press the OVEN function button and set the temperature to 250°C/480°F. Press the TIMER button and set the oven to operate for a maximum of 20 minutes. It is important to ensure adequate ventilation during this period.
Be sure that you have removed all packing material, plastics, and have placed the oven rack in position before plugging the cord into the outlet for use. After use allow the oven to cool down completely before unplugging the appliance.
During usage of the oven the digital display panel will show current function being used as well as the time remaining. At the end of a cooking cycle, the word “END” will blink in the display and a beeping noise will continuously sound until you press the “STOP / CANCEL” button or one (1) minute has passed.
7
