Installation Instructions
ELECTRICAL CONNECTIONS (CONT.)
6 3-WIRE CONDUIT INSTALLATION
ALoosen the 3 lower terminal screws from the terminal block. Insert the center bare wire (white/neutral) tip through the bottom center terminal block opening. On certain models, the wire will need to be inserted through the ground strap opening and then into the bottom center block opening. Insert the two side bare wire tips into the lower left and the lower right terminal block openings. Tighten the screws until the wire is firmly secure (approximately 20
NOTE: ALUMINUM WIRING:
Aluminum building wire may be used but it must be rated for the correct amperage and voltage to make connection. Connect wires according to this Step 6 or Step 7 depending on number of wires.
Terminal 
block
7 4-WIRE CONDUIT INSTALLATION
ALoosen the three lower terminal screws from the terminal block. Remove the ground screw and ground plate and retain them.
Cut and discard the ground strap. DO NOT DISCARD ANY SCREWS.
BInsert the ground bare wire tip between the range frame and the ground plate (removed earlier) and secure it in place with the ground screw (removed earlier). Insert the bare wire (white/neutral) tip through the bottom center of the terminal block opening. Insert the two side bare wire tips into the lower left and the lower right terminal block openings. Tighten the screws until the wire is firmly secure (approximately 20
Before | Ground strap |
| |
Terminal | or |
block |
|
Cut and discard |
|
the ground strap | Neutral terminal |
|
Wire tips
Bracket 
Conduit
Wire used, location and enclosure
After
Terminal block
Wire tips
Ground screw
Ground
plate
(grounding 
to range)
of splices, etc., must conform to good wiring practices and local codes.
BSkip to Step 8 and proceed with the installation.
Bracket
Wire used, location and enclosure
of splices, etc., must conform to good wiring practices and local codes.
CProceed to Step 8.
18
8 REPLACE THE WIRE COVER
Replace the wire cover on the range back by sliding its two lower retaining tabs into the slots and replacing the screw removed earlier. Make sure that no wires are pinched between the cover and the range back.
