Avaya X330W-2DS1 Connect the Ports, Connecting the E1/T1 Ports, Connecting the Ethernet Port

Connect the Ports

Connecting the E1/T1 Ports

To connect a T1/E1 module to a network, use a straight-through RJ-48C-to-RJ-48C cable to connect the E1/T1 port to an RJ-48C wall jack.

Connecting the Ethernet Port

A UTP Category 5 cable must be connected to the 100Base-TX port, via an RJ45 connector. The maximum UTP cable length connected to the 10/100 Mbps port operating as 10/100Base-T is 100 m (328 ft.).

You can obtain appropriate cables from your local supplier.

If you are connecting the Fast Ethernet port to a PC or workstation, you should use a crossed cable.

If you are connecting the Fast Ethernet port to another switch, you should use a straight cable.

Connecting the Console Port

Each Avaya X330WAN module has one serial port on the front panel for connecting a terminal, a terminal emulator, or a modem. The serial port on the front panel is labeled “Console” and has an RJ-45 socket.

1.Insert the RJ-45 plug on the console cable into the Console port of the Avaya X330WAN

	module.	4
2.	Insert the other end into the RJ-45 socket in the supplied DB-9 adapter.
3.	Insert the DB-9 plug into the serial (COM) port on the PC or terminal.
	To connect a modem, use the cable and an RJ-45 to DB-25 adapter.

The cable and two adapters can be found in the Avaya P330 accessory set supplied with P330 switches, and they are clearly marked.