Avaya X330W-2DS1 quick start Configuring Loopback Interfaces, Configuring Fast Ethernet Interfaces

Configuring Loopback Interfaces

All CLI commands mentioned in this section are described in the Avaya P330 Reference Guide.

To configure Loopback interfaces:

1.Use the interface loopback <loopback number> command to enter the Interface Loopback mode. For example, typing interface loopback 1 configures a loopback with a Loopback interface number 1.

The prompt changes to p330WAN-N(super-if:Loopbackn)#where N is the switch number and n is the loopback interface number.

2.Use the ip address <ip_addr><net-mask>command to assign an IP address and subnet mask to the interface.

3.Type exit to return to Supervisor mode. The prompt returns to p330WAN-N(super)#.

X The following displays:

The primary management interface has changed. For this change to take effect, you need to copy running-config startup-config and then reset the device.

4.Enter the following commands:

copy running-config startup-config reset

Configuring Fast Ethernet Interfaces

All CLI commands mentioned in this section are described in the Avaya P330 Reference Guide.

To configure Fast Ethernet interfaces:

1. Type interface FastEthernet 1 to enter the Interface Configuration mode. The prompt changes to p330WAN-N(super-if:FastEthernet1)#.

5 2. Use the ip address <ip_addr><net-mask>command to assign an IP address and subnet mask to the interface.

3.Type exit to return to Supervisor mode.

The prompt returns to p330WAN-N(super)#.