Avenview FO-DVI-DL-330X specifications Installation, Function Switch

1.8Installation

Avenview FO-DVI-DL-330X is composed of a transmitter and a receiver. The Transmitter should be connected to the computer’s DVI Port and the Receiver should be connected the DVI Port of the digital display device. Avenview FO-DVI-DL-330X Transmitter is designed to be used with the LC type standard optical cable. Transmitter and Receiver have each of 7 Optical port which are marked on the optical port of the fiber cable connection.

To setup Avenview FO-DVI-DL-330X follow these steps for connecting to a device:

1.Connect FO-DVI-DL-330X Transmitter unit to DVI source

2.Connect FO-DVI-DL-330X Receiver unit to DVI port of display.

3.Connect 2 Strand Fiber Optic LC Type cable to both Transmitter and Receiver.

4.Plug the power to Receiver Unit.

5.Power on DVI Source and DVI Display.

Use the DC adapter (included in the package) for the Receiver. The Transmitter which is connected to a computer uses power from the computer.

If Transmitter power LED doesn’t light up after PC is turned on, then use the external power adapter for Transmitter.

1.9Function Switch

EDID: Switch in front of Transmitter

-REAL: EDID data of connected monitor is transmitted between Transmitter and Receiver in real time through UTP cable.

-Emulation: Certain EDID data pre-set in the Transmitter is used in signal transmission. UTP cable is not necessary.

EDID: Switch in front of Transmitter

-Single: When you use Single link display, select ‘Single’ switch.

-Dual: When you use Dual link display, select ‘Dual’ switch.

www.avenview.com 8