Avenview SW-HDM3D-C5-8X8 Dip Switch for EDID & Audio Settings SW1 - SW8, DIP Switch Position

1.7.4 Dip Switch for EDID & Audio Settings (SW1 – SW8)

DIP Switch Position		Video	Audio	Description
PIN # 1	PIN # 2
OFF 	OFF 	1080p	Surround	Default Mode 11: EDID up to 1080p video & surround
				sound audio output up to 7.1ch (DTS-HD Master &
				Dolby TrueHD)
OFF 	ON 	Up to 1080p	Stereo2	Default Mode 2: EDID up to 1080p video and stereo
				audio for basic compatibility among HDTVs
ON 	OFF 	Up to	Stereo	Safe Mode3: EDID up to 720p/1080i video and stereo
		720p/1080i		audio for basic compatibility among HDTVs
ON 	ON 	Bypass4	Bypass4	EDID Learning Mode5: for learning EDID from the
				display while playing any received HDMI audio format

1Factory default setting of [SW1]-[SW8] is pin-1 at OFF [] & pin-2 at OFF [] for 1080p video and surround sound audio.

2If the HDTV shows video but without audio, please try to set audio mode to stereo.

3If you encounter any unsolved audio/video output problem during system installation, please turn any [SW1]-[SW8] to pin-1 at ON [] & pin-2 at OFF [] for safe mode to select the system EDID up to 720p(1080i) video and stereo audio for system check. However, the safe mode cannot be initiated if your HDMI source is set to enforce 1080p output. In this case, please reconfigure your HDMI source to all resolution output for troubleshooting.

4Bypass means the matrix will maintain playing the original format of HDMI signals in video and perhaps audio. By setting at this mode, the users may encounter compatibility issue among different kinds of HDMI sources and displays. If you cannot get the audio and/or video output normally at the system installation, please change the DIP switch setting to default mode or even safe mode to verify the functionality of the device.

5To learn the EDID of HDMI display for respective HDMI source devices, please see the [EDID Learning] section in the next page for more information

www.avenview.com 9