SET EN INAP [PAP/MSCHAP_V2]
Sets the EAP inner authentication protocol.
SET EN IROAM [DISable/STRICT/FLEXible]
Controls whether the radio frequencies are set based on the radio configuration or
from its access point. Disabled uses the radio defaults. When in Ad-Hoc mode, you
must set the region of operation. See “SET EN REGDOMain”. Flexible uses
access point settings if present; otherwise the radio defaults are used. When in Ad-
Hoc mode, you must set the region of operation. See “SET EN REGDOMain”.
Strict the access point regulatory frequency information. When using an access
point, there is no need to set the region of operation.
SET EN PW <password>
Sets the password for 802.11b/g EAP authentication.
SET EN KEY# <1/2/3/4>
Sets which WEP key number to use (default is 1).
SET EN KEYVAL <WEPkey>
Sets WEP key value. Must be hexadecimal.
SET EN MODE [IN/AD]
Sets 802.11b/g wireless mode to infrastructure or Ad-Hoc mode.
SET EN RAdio [802.11b/802.11b-g]
Sets the radio type.
SET EN REALM <realm>
Sets the realm portion of the 802.11b/g EAP authentication ID.
Telnet Console Commands 6-9