![](/images/new-backgrounds/1192352/1923527x1.webp)
Single port PS2 KVM over IP
1. The Quick Installation Guide
Installation
PS/2 KVM over IP switch redirects local keyboard, mouse and video data to a remote administration console. All data is transmitted via IP. PS/2 KVM over IP switch can be used in a multi administrator and multi server environment as well. Besides this, PS/2 KVM over IP switch is a KVM switch, which can also be used with a local console.
PS/2 KVM over IP hardware installation
Host
Console
Figure 1.1 The connectors of single port PS/2 KVM over IP Front and rear side
Please perform the following steps:
1.Connect the power supply on PS/2 KVM over IP switch
2.Connect the monitor to the PS/2 KVM over IP switch console side.
3.Connect the keyboard to the PS/2 KVM over IP switch console side.
4.Connect the mouse to the PS/2 KVM over IP switch console side.
5.Connect a VGA cable (15-pin HDDB Male / Male) with the Male side to both of the PC and the host port of the PS/2 KVM over IP switch.
6.Connect one purple end of 3-in-one cable to the PS/2 mouse port on the computer, and the other end of 3-in-one cable to the host PS/2 mouse port on the PS/2 KVM over IP Switch.
7.Connect one green end of 3-in-one cable to PS/2 keyboard port on the computer, and the other end of 3-in-one cable to the host PS/2 keyboard port on the PS/2 KVM over IP switch.
8.Connect Ethernet and/or modem, depending how you want to access PS/2 KVM over IP switch
Video modes
PS/2 KVM OVER IP recognizes a limited number of common video modes. When running
Initial IP configuration
Initially the PS/2 KVM over IP switch network interface is configured with the parameters shown in Table 1.1.