Axis Communications 232d+ 48AXIS 231D+/232D+ - Connection Module, Connection Module Pinout

48AXIS 231D+/232D+ - Connection Module

Connection Module

This section describes the pinout provided by the Connection module consisting of:

•4 transistor outputs

•4 digital inputs

•power and GND (ground)

not used

24V AC Power

4 transistor outputs

4 digital inputs (see table below)

The inputs/outputs are used in applications for event triggering, time lapse recording, alarm notification via email, and picture storage to FTP locations, among others.

•Input - for example a doorbell. If the doorbell is pressed, the state changes, and the input is active (shown under Event Configuration > Port Status).

•Output - for example, an alarm device that can be activated from Output buttons from the Live View page or as an action to an Event Type. The output shows as active (under Event Configuration > Port Status), if the alarm device is acti- vated.

Connection Module Pinout

Function	Description	Function	Description
n/a	not used	GND	ground
n/a	not used	GND	ground
n/a	not used	Transistor Output 4	See below
n/a	not used	Digital Input 4	See below
n/a	not used	Transistor Output 3	See below
n/a	not used	Digital Input 3	See below
n/a	not used	Transistor Output 2	See below
PS GND	ground	Transistor Output 1	See below
24 VAC	24 VAC	Digital Input 2	See below
24 VAC	24 VAC	Digital Input 1	See below

Digital Input (1-4)- connect to GND to activate or leave floating (unconnected) to deactivate

Transistor Output (1-4)- Max. load 100mA, max. voltage 24V DC. An open-collector NPN transistor with the emitter connected to pin 2 (GND). If used with an external relay, a diode must be connected in parallel with the load for protection against any voltage transients.

1.Loosen the corresponding screw on top of the pin (see the table above to determine which pin to use).