AXIS P1214 Network Camera
Hardware Overview
Note
•The Status LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options > Ports & Devices > LED. See the online help for more information.
•The Status LED can be configured to flash while an event is active.
•The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .
Shorten Sensor Unit Cable
The sensor unit is delivered with a cable. To shorten the cable follow these steps:
1.Cut the cable to the desired length. Measure from the sensor unit.
2.Strip the plastic outer coating from the end of the cable.
3.Peel back the shield.
4.Flatten the colored wires in the order described below.
1Brown
2White/brown
3Not used
4Not used
5White/blue
6Blue
NOTICE
Make sure that the wires stay in the correct order and that the cable shield makes good contact with the connector shield.
5.Insert the wires all the way into a shielded 6P6C RJ12 connector.
6.Use a crimping tool to fasten the connector to the cable.
8