5
Connect the hot and cold supplies
Connect the hot and cold supply hoses to the
supplies with standard 3/8” compression fittings
(included). Use two wrenches, as shown in the
diagram. Tighten the compression fittings wrench
tight.
User instructions
The spout swivels a full 360o. Do not swivel
the spout further than 360o, or damage
to the hose will result.
Push the handle to the right to turn the water on,
to the left to turn the water off. Swivel the handle
forward for cooler water, back for warmer water.
Press and hold the diverter to activate the spray
mode. Release the diverter to return to stream
mode.
If the flow of water decreases, remove and clean
the filter.
Do not allow either hose to twist.
Twisting the supply hose may cause
it to loosen from the faucet, which
may cause water damage.
English
filter
diverter