4
Install the hose weight
Proper installation of the hose weight will insure
that the handspray retracts smoothly.
On the handspray side of the hose, measure 15”
down from the body of the faucet. Install the
weight at this point.
Pull out on the handspray. It should move easily
and retract smoothly. Reposition the weight as
necessary.
Make sure that the hot and cold supply hoses do
not interfere with the handspray hose. They can
be repositioned slightly if necessary.
Install the handle
Install the Boltic™ handle screw on the stem.
Tighten only 4 turns.
Place the handle over the stem and handle
screw. Press the handle firmly into place.
Use the 4mm hex wrench to finish tightening
the screw.
Install the screw cover.
English
Connect the handspray hose
Connect the handspray hose to the handspray sup-
ply hose with the nut, cone washer, flat brass washer
and rubber washer as shown.
Do not allow either hose to twist.
Twisting the supply hose may cause
it to loosen from the faucet, which
may cause water damage.
Twisting the handspray hose may
cause reduced water flow to the
handspray.