16510XX1& 16803XX1: Connect the supply lines to the stops with 3/8” compression fittings (not included). Use two wrenches, as shown in the diagram, to keep the supply hoses from twisting.
Turn on the water and check all connections for leaks.
Install the pop-up drain (16510XX1 only)
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the threads with TeflonTM thread tape and replace.
Install the white, flexible sealing gasket to the flange. Place it in the sink outlet.
From under the sink, install the black mack gasket, white friction ring , and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time.
Thread the tee and tailpiece to the flange. The pivot must face the faucet. If necessary, turn the drain assembly.
Tighten the retainer nut.
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes through the loop in the bottom of the height adjuster.
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the horizontal rod.
Attach the swivel connector to the end of the pull rod. Position as desired, and tighten with a small, flathead screwdriver.
plunger assembly height adjuster
outlet flange pull rod
sealing gasket mack gasket friction ring retainer nut
tee |
|
pivot ball seal |
|
pivot ball |
|
pivot ball |
|
nut |
|
horizontal rod |
|
swivel connector | tailpiece |
5