Use 3/8” compression fittings (not included) to con- nect the supply hoses to the hot and cold stops. Use two wrenches, as shown in the diagram, to prevent hose twisting.
For proper operation of the faucet, the hot supply should be on the left, and the cold supply should be on the right.
Install the
Turn on the water and check all connections for leaks.
If desired,
Install the Pop-up Drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread tape and replace.
Install the white, flexible sealing gasket to the flange. Place it in the sink outlet.
From under the sink, install the black mack
gasket, white friction ring and retainer nut pull rod to the flange. Do not tighten the nut against
the bottom of the sink at this time.
Thread the tee and tailpiece to the flange. The pivot must face the faucet. If neces- sary, turn the drain assembly.
Tighten the retainer nut.
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes through the loop in the bottom of the height adjuster.
Install and hand tighten the pivot ball nut.
plunger
height adjuster
flange
sealing gasket 
mack gasket
friction ring
retainer nut
tee
pivot ball nut
tailpiece
horizontal rod
swivel connector
