![](/images/new-backgrounds/1254581/25458137x1.webp)
Speaker Components
(L) (R) |
|
|
02 Connections![](/images/new-backgrounds/1254581/25458137xi2.webp)
FRONT/FRONTTOP | STAND | SUBWOOFER | TX Card |
| (L) (R) |
|
|
|
| Wireless Receiver Module | Speaker Cable (2EA) |
SCREW (4x20): 16EA |
|
|
|
SCREW : 6EA SURROUND
CENTER
STANDBASE:4EA SPEAKERCABLE
Installing the Speakers on the Tallboy Stand
1. | Turn the Stand Base |
| the Stand. |
2. | Insert small screws (4x20, For connecting Stand & |
| Stand Base) clockwise into the four holes marked |
| using a screwdriver as shown in the illustration. |
! CAUTION | |
When you use a torque screwdriver, be careful not | |
| to put excessive force. Otherwise, it runs idle or |
| can be damaged. (torque screwdriver- below 15 |
| kg.f.cm) |
3. | Insert the large screw (5x15, For connecting Stand |
| & Stand Base) clockwise into the hole on the rear of |
| the stand using a screwdriver. |
1 |
Stand Base |
Stand |
3 |
4 Speaker
Stand
4. | Connect the upper Speaker to the assembled |
| Stand. |
5. | Insert another large screw (5x15, For connecting |
| Speaker & Stand) clockwise into the hole on the rear |
| of the speaker using a screwdriver. |
6. | This is the appearance after the speaker is installed. |
| Follow this steps to install other speaker. |
56