Axor 06110XX0, Scroll handle 06124XX0, Lever handle 06123XX0, Interaktiv S 06876XX0 Limbo, Tango

Limbo

Screw the socket onto the diverter.

Insert the ball rod into the socket.

Press the white plastic retainer clip over the ball rod. Press into place over the socket.

Press the diverter assembly firmly into the spout tee until it is fully seated.

Firmly press the spout over the tee and diverter. Tighten the set screw with the included 3 mm Allen wrench.

CAUTION: do not overtighten the set screw or the o-rings on the diverter will deform, which will cause a leak.

Use the included wrench to hold the threaded rod steady. (It may be necessary to use a needle-nosed plier to pull up on the threaded rod to expose the wrench flats).

Install the diverter knob.

Tango

Install the pin onto the diverter.

Press the guide bushing firmly into place. The hole in the pin should be clearly visible through the slot in the guide bushing.

Press the diverter assembly firmly into the spout tee until it is fully seated. Turn the guide bushing so that the slot faces the rear of the spout.

6