Interaktiv and Swing
Screw the nut onto the diverter. Screw the shorter threaded end of the threaded rod into the nut. Slide the rod trim onto the rod and screw into place so that a few threads protrude from the top.
Firmly press the diverter assembly straight into the spout tee until it is fully seated.
Swing only: install the spout deco ring on the spout. Make sure that the set screw hole in the deco ring lines up with the set screw hole in the spout.
Press the spout over the tee and diverter. Install the set screw and tighten it with a 3mm Allen wrench (included).
CAUTION: do not overtighten the set screw or the
Install the diverter knob.
5