If the Engine will be run in temperatures below 32 degrees Fahrenheit, use SAE
3.To do so, unscrew and remove the Oil Dipstick (65A). Pour engine oil into the oil fill hole until the level of oil is even with the bottom edge of the oil fill hole (if you cannot see the oil through the oil fill hole, then the oil is too low and more oil must be added). (See Figure D.)
4.Make sure to screw the Oil Dipstick (65A) firmly back into its Dipstick Hole.
(See Figure D.)
To Fill The Fuel Tank:
1.Prior to first using the Generator, the Fuel Tank (31) must be filled with high octane unleaded gasoline. (See Figure D.)
2.To do so, remove the Fuel Tank Cap (34) and fill the Fuel Tank (31) with unleaded gasoline. Then, replace the Fuel Tank Cap. Thereafter, check the Fuel Gauge (35) for the amount of unleaded gasoline. When necessary, refill the Fuel Tank.
(See Figure D.)
NOTE: Periodically, make sure to check the Fuel Filter (32) for excessive dirt and debris. If necessary, remove the Fuel Filter and clean with compressed air.
(See Figure D.)
THIS UNIT CAN POWER THE FOLLOWING ITEMS
ITEM | RUNNING | |
| WATTS | WATTS |
1 HP Air Compressor | 1600 | 4500 |
Belt Sander | 1200 | 2400 |
Pressure Washer | 1200 | 3600 |
Refrigerator/Freezer | 700 | 2200 |
1/2 HP Sump Pump | 1050 | 2150 |
1/2 HP Well Pump | 1000 | 2100 |
Miter Saw | 1650 | 3000 |
1400 | 3100 | |
Run Motor |
|
|
Central | 5000 | 6500 |
10” Table Saw | 1800 | 4500 |
NOTE: Wattages listed above are estimates. Check nameplate wattages on all loads before connecting to Generator.
SKU 56088 | For technical questions, please call | Page 14 |