Grounding The Generator:
GROUNDING TERMINAL
(9)
#6 AWG GROUNDING WIRE
(NOT INCLUDED)
GROUNDING ROD
(NOT INCLUDED)
FIGURE B
Note: It is recommended that only a trained and licensed electrician perform this proce- dure.
Connect a #6 AWG grounding wire (not included) from the Grounding Terminal (9) on the Generator to a grounding rod (not included) that has been driven at least 24 inches deep into the earth. The grounding rod must be an
(See Figure B.)
CONTROL PANEL FEATURES
1.Engine Ignition (2): Starts and stops the Gasoline Engine. To start the Engine using power from the Battery (45), insert the Ignition Key (65) and turn the Engine Ignition to its “START” position. To start the Engine manually using the Starter Rope (40A) and Starter Handle (41A), insert the Ignition Key and turn the Engine Ignition to its “RUN” position. Then pull briskly on the Starter Handle. To stop the Engine, turn the Engine Ignition to its “OFF” position. Always remove the Ignition
Key when the Generator is not in use. (See Figure C, next page.)
2.Fuel Tank Cap (34): NEVER run the Engine with the Fuel Tank Cap removed.
(See Figure C.)
3.120 Volt NEMA AC Outlets (5): The Generator is equipped with four
SKU 56088 | For technical questions, please call | Page 11 |