Harbor Freight Tools 56088 warranty Figure F, Engine maintenance, Figure G, PLUG 59A, Oil Dipstick

PLUG (59A)

	OIL DIPSTICK
FIGURE F	(65A)

4.Engine maintenance:

a.After first 5 to 8 hours of use: Change oil. Then, change oil every 50 hours of use. Change oil every 25 hours of use when operating the Engine under a heavy load or in high temperatures. To change the oil, remove the Plug (59A) and allow the old oil to drain in a proper container. Once drained, replace the Plug. If the Engine will be run in temperatures above 32° Fahrenheit, use SAE 10W-30weight oil. If the Engine will be run in temperatures below 32° Fahr- enheit, use SAE 5W-30weight oil. To fill the Engine crankcase with new oil, unscrew and remove the Oil Dipstick (65A). Pour engine oil into the oil fill hole until the level of oil is even with the bottom edge of the oil fill hole (if you cannot see the oil through the oil fill hole, then the oil is too low and more oil must be added). Make sure to screw the Oil Dipstick (65A) firmly back into its Dipstick

Hole. Also, make sure to dispose of the old oil according to local waste disposal requirements.(See Figure F.)

SPARK PLUG (28A)

SPARK PLUG WIRE (36A)

FIGURE G

AIR FILTER SEPARATOR

(20A)

AIR FILTER COVER

(18A)AIR FILTER ELEMENT

(19A)

b.After every 25 hours of use: Service the Air Filter Element (19A) and Air Filter Separator (20A). To do so, remove the Air Filter Cover (18A). Remove the Air Filter Element. Immerse the Air Filter Element in a mild solvent and squeeze the Element several times to clean. Remove the Element from the solvent

SKU 56088 For technical questions, please call 1-800-444-3353. Page 18