Harbor Freight Tools 56088 Unpacking, Assembly Instructions, To Install The Battery not included

UNPACKING

When unpacking, check to make sure all the parts shown on the Parts Lists on pages 20 and 22 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

ASSEMBLY INSTRUCTIONS

CAUTION! Make sure Engine’s Ignition (2) is in its “OFF” position prior to per- forming any service, maintenance, or cleaning of Generator or Engine. Always wear ANSI- approved safety impact eye goggles when assembling and using the Generator.

To Install The Battery (not included):

NOTE: For proper operation, you must install a DC 12V, 18-35 Amp-hour Battery.

NEGATIVE BATTERY CABLE

(64)

BATTERY			POSITIVE BATTERY CABLE
(45)
Not included	(63)
		BATTERY GUARD PLATE (44)
		(FACTORY PRE-INSTALLED)
BATTERY BRACKET
(47)		BATTERY TRAY (48)
		(FACTORY PRE-INSTALLED)
BOLT W/LOCK WASHER			FIGURE A
(46)

1.Remove the packing from the Battery (45). Then, locate the factory pre-installed Battery Guard Plate (44) and Battery Tray (48) beneath the Control Panel (4) of the Generator unit. (See Figure A, previous page.)

2.Slide the Battery (45) into the Battery Guard Plate (44), with the Battery’s terminals facing outward and with the Battery’s negative (–)terminal facing left.

(See Figure A.)

3.Align the two mounting holes in the Battery Bracket (46) with the two threaded mount- ing holes in the Battery Guard Plate (44). Then secure the Battery Bracket to the Battery Guard Plate, using two Bolts with Lock Washers (46). (See Figure A.)

SKU 56088 For technical questions, please call 1-800-444-3353. Page 9