Harbor Freight Tools 56088 Pre-Start Instructions, To Add Engine Oil, Figure D, See Figure C

8.12 Volt DC Fuse (8): The 12 Volt DC Outlet has one Fuse (8) to protect the Gen- erator from overloading. The Generator is equipped with the following size and type of Fuse: F10A250V. Should a 12 VDC output exceed the fuse’s rating, always check to see if the Fuse has “blown” (a melted filament within the Fuse). If neces- sary, unplug all electrical loads from the Generator, replace with a new Fuse, and reattach a reduced load to the generator. (See Figure C.)

9.Power-On Light (10): Indicates voltage is being provided by the Generator.

(See Figure C.)

PRE-START INSTRUCTIONS

To Add Engine Oil:

1.CAUTION! Your warranty is voided if you do not put engine oil in the Engine’s crankcase prior to its first use. Before each use, check the oil level. Never run the

Engine with low or no engine oil. Running the engine with low or no oil will perma- nently damage the Engine.

OIL DIPSTICK

(65A)

FUEL TANK CAP

FUEL FILTER (34) (32)

FUEL GAUGE

(35)

FUEL TANK

(31)

THIS GENERATOR HAS AN AUTO- SHUTDOWN OIL SENSOR. IF ENGINE STOPS OR WILL NOT START, CHECK OIL LEVEL.

FIGURE D

2.The Engine MUST be filled with a high quality grade engine oil. If the Engine will be run in temperatures above 32 degrees Fahrenheit, use SAE 10W-30weight oil.

SKU 56088 For technical questions, please call 1-800-444-3353. Page 13