Azden 1201URX/AB, 1201URX/Si Table of Contents, Setting the Transmitting Frequency on the 1201XT

TABLE OF CONTENTS
1201URX SERIES RECEIVER VIEW		i
INTRODUCTION		ii
RECEIVER (1201URX/AB and 1201URX/VM) SETUP		1-2
Attaching the Antennas		1
Connecting the Output Cable		1
Setting the Receiver’s Frequency		1-2
Power		2
Output		2
Monitor		2
LCD Display		2-4
The 1201URX/Si		4
Mode		4-5
Up/Down		5
Powering the 1201BT Transmitter		6
SETTING THE TRANSMITTING FREQUENCY ON THE 1201BT		6-7
USING THE 1201BT TRANSMITTER’S CONTROLS AND DISPLAY		7
Power		7
Audio		7
MIC		7
Input Level Adjustment		7
Belt Clip		7
Antenna		8
Display		8
THE 1201XT		8
Powering the 1201XT		8-9
SETTING THE TRANSMITTING FREQUENCY ON THE 1201XT		9
USING THE 1201XT TRANSMITTER’S CONTROLS AND DISPLAY		10
Power		10
Audio		10
MIC Connector / Locking Ring		10
Input Level Adjustment		10
Display		11
SPECIFICATIONS	Back Page
LICENSING	Back Page
CONFORMITY		Insert
iii

POWERING THE 1201XT (continued)

in the illustration. The compartment is deigned to ease battery insertion - With the correct polarity. DO NOT FORCE THE BATTERY INTO THE COMPART- MENT. Azden does not recommend the use of rechargeable batteries.

SETTING THE TRANSMITTING FREQUENCY ON THE 1201XT

Before the 1201XT can be used, it and the associated receiver have to be set to the same frequency. This can be accomplished on the 1201XT transmit- ter by first setting the LCD display to one of the two views - ‘Frequency’ or ‘Channel’. To do this ,after installing fresh batteries, turn the 1201XT to the ON position [r]. Next, using the tip of a ballpoint pen, an unbent paper clip or something similar, press the MODE button [n] repeatedly until one of the two screens below appears.

Using either the UP or DOWN button [o] the desired receiving frequency or channel number can be set. Tapping the button steps the frequency or channel number one at a time while pressing and holding the button in moves through the frequencies or channel numbers rapidly. There are 188 different frequencies or channel numbers to choose from. Once the desired frequency or channel number has been determined be certain to set both the transmitter and the receiver to match.

9