B&B Electronics 2011 manual General Information, Features, Description

2.0 GENERAL INFORMATION

Thank you for your purchase of this B&B Electronics product. This

product has been thoroughly inspected and tested and is warranted for one year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to contact B&B Electronics Technical Support at (815) 433-5100.

2.1 FEATURES

•Conforms to CCITT V.22 and V.14 Standards

•Lets asynchronous terminals communicate with synchronous modems and multiplexers

•Accepts character lengths to 11 bits

•Requires no AC power or batteries

•Supports data rates to 64 Kbps

•Automatically adjusts synchronous data rates

•Miniature size

•Plugs directly into async. or sync. DB-25 port

•Accepts external clocking

•Made in the USA

2.2 DESCRIPTION

The B&B Model 2011 asynchronous to synchronous converter plugs directly into a local asynchronous DTE (terminal, PC, etc.) and connects that DTE, via RS-232 cable, to a synchronous DCE. When the same set-up is installed on the remote end, the local and remote DTEs can communicate over the synchronous link.

Drawing power from either the synchronous or asynchronous RS-232 interface, the Model 2011 needs no AC power or batteries to operate and supports RS-232 data rates from 64 Kbps. Because the Model 2011 automatically adjusts the synchronous data rate to match the asynchronous DTE's output rate, no data rate strapping is

necessary. The Model 2011 derives clocking externally from the clock of the synchronous DCE, and imposes no limit on data block size. Characters may be up to 11 bits long.

Measuring only 3.2" x 2.0" x .75", the Model 2011 is housed in a sturdy ABS plastic case. It comes fully equipped with a DB-25 male connector and a DB-25 female connector, which plug directly into the synchronous and asynchronous ports.

2 2011AS3297 Manual

B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350

PH (815) 433-5100 -- FAX (815) 434-7094