Figure 3. RS-485 Wiring Diagram

4-Wire Mode

To configure the 485DSS for RS-485 or 422 four-wire mode, place the jumper in the 4W position. Refer to Figure 4 for connecting information and Figure 2 for the jumper location. In this position on a 4-wire network the Host and the RS-232 device can communicate in full duplex. CAUTION: Data loss may occur if the Host sends 485DSS commands while the host is receiving data from the network!

6485DSS-0308 Manual

B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91 792444 – Fax +353 91 792445

Page 10
Image 10
B&B Electronics 485DSS manual RS-485 Wiring Diagram Wire Mode