Quick Start Guide
Elinx Managed Ethernet Switch
EIR610 Series
1 | Items Included |
oEthernet Switch
oConsole Cable
o This Quick Start Guide o Panel Mount Bracket
2 | Default Settings |
oIP Address: 192.168.16.1
oSubnet Mask: 255.255.255.0 o Gateway: 192.168.16.254
o User Name: root, Password: root
3
LED Chart
|
|
|
|
|
LED |
| Status | Meaning | |
PWR |
| Green | The Switch is powered on | |
| Off | The Switch is powered off | ||
|
|
| ||
PWR1 |
| Green | Power Source 1 is available | |
| Off | Power Source 1 is unavailable | ||
|
|
| ||
PWR2 |
| Green | Power Source 2 is available | |
| Off | Power source 2 is unavailable | ||
|
|
| ||
Fault |
| Red | Power or Port failure | |
| Off | Normal Operation | ||
|
|
| ||
|
|
| Green | The Switch is the master of a redundant |
R.M |
| ring | ||
|
| |||
| Off | The Switch is not the master of a | ||
|
|
| ||
|
|
| redundant ring. | |
|
|
|
| |
LINK/ACT |
| Green | SFP Port is linked | |
P7/9/10* |
| Blinking | Data is being transmitted or received | |
SFP |
| Off | Not connected to the network | |
Port |
| T | Green | Port is linked |
| T | Blinking | Data is being transmitted or received | |
7/9/10* |
| T | Off | Not connected to the network |
| B | Green | Operating at 1000M | |
|
| B | Off | Disconnected or below 1000M |
|
| T | Green | Connected to the network |
|
| T | Blinking | Data is being transmitted or received |
| T | Off | Not connected to the network | |
| B | Yellow | Operating in | |
|
| |||
|
| B | Blinking | Data collision |
|
| B | Off | |
*Note |
| |||
| 7, 9, and 10 are 100/1000 | |||
|
| |||
|
|
|
|
|
EIR610
4
Hardware Installation
oRecord the switch’s MAC Address in the space provided. The MAC Address is printed on the product label. NOTE: Provide the MAC Address to your
Network Administrator. The Network Administrator
should provide an IP Address, Subnet Mask, and Gateway.
oSelect a mounting location and install with the attached DIN rail clip or included panel mount kit.
oConnect power to the switch o 12 to 48 VDC
oRedundant inputs are available with fault contacts.
NOTE: The installation of an SFP Module disables the associated
5 | Log into the Switch |
|
oThese instructions are for Web based management.
Refer to the User’s Manual for instructions concerning console management.
oConnect a switch port to a stand alone PC. Change the PC’s network IP Address to allow it to connect to the
switch (ex: 192.168.16.2). Use the default subnet mask and gateway.
oLaunch the PC’s web browser and navigate to the switch by typing the switch’s IP Address in the browser address window.
oNavigate the web page by expanding the folders on the left side of the web page.
International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA
European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland +353 91 792444 Fax +353 91 792445
