B&B Electronics UNO-2170 user manual Inserting a CompactFlash Card, Chassis Grounding

Chapter 3 Initial Setup

3.1 Inserting a CompactFlash Card

The procedure for installing a CompactFlash™ card into the UNO-2170 is detailed below, please follow these steps carefully.

1.Remove the power cord.

2.Unscrew the four screws from the rear panel of the UNO-2170.

3.Remove the rear panel.

4.Plug a CompactFlash™ card with your OS and application program into a CompactFlash™ card slot on board.

5.Screw back the rear panel with four screws.

Note The CompactFlash™ slot is allocated as“Secondary IDE Master＂

3.2 Chassis Grounding

The aluminum made UNO-2170 provides good EMI protection and a stable grounding base. There is an easy-to-connect chassis grounding point for you to use.

Please connect chassis ground of UNO-2170 with "EARTH" as ground.

Figure 3.1: Chassis Grounding Connection

UNO-2170 User Manual 18