SAFETY

SAFETY

Shoulder Strap

position that places the shoulder strap level with, or below the top of the child’s shoulder and feed the shoulder harness under the correct loop. To adjust harness slot unhook

PLATFORM - Safety Belt

• Secure the stand feature safety belt behind child and engate buckle (Fig. 22). This is the same safety belt you use to secure the rear

Waist Strap

Squeeze

Adjust for a snug fit

the shoulder strap from the crotch buckle. (Fig. 17) Feed the shoulder strap through the harness spread slots. You can access these slots from the rear of the seat. Feed shoulder strap through appropriate slot and reattach shoulder strap to crotch buckle.

infant car seat.

Crotch Strap

Fig. 18

Fig. 19

Fig. 20

Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the shoulders. Place the crotch strap and between the child’s legs. Insert the male end of each shoulder / waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders. (Fig.18)

To release, apply pressure to both sides of each male clip until the clip is released. (Fig. 19) This process requires a moderate amount of effort so as to prevent an accidental release by your child.

NOTE: Buckles may be hard to release when 1st used.

TRAVEL SYSTEM - Safety Belt

• Strap the safety belt over the infant car seat through the seat belt slots on the infant car seat, connect the buckles together (Fig. 20). The safety belts for the infant car seat is located in small pockets on outer sides of seat pads. Tighten the strap so the infant car seat fits snug and can't move.

IT IS VERY IMPORTANT THAT THE INFANT CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED AROUND THE INFANT CAR SEAT.

TO RECLINE SEAT

Fig. 22

FRONT SEAT

 

The front seat has a two position recline. To

 

recline the seat, rotate the recline bar and press

 

backward on the seat back. (Fig. 23) To place the

 

seat in the upright position, press upward on the

 

seat back while rotating the recline bar.

 

WARNING: The upright

Fig. 23

position should be used only for a

 

child that is at least 6 months old.

 

TO ATTACH INFANT CAR SEAT To attach Baby Trend infant car seats (Fig. 24), rotate child trays to the vertical postion first. See rotate child tray for more details.

WARNING: Avoid serious

Fig. 24

 

injury from falling, ALWAYS use

 

the safety belt to secure the infant

 

car seat.

 

Recline the front seat back. Postion the infant car

 

seat, facing toward the rear of the stroller, so the

 

seat shell goes into the front child tray and latches

 

into place. (Fig. 25)

 

Check that the infant car seat is firmly locked onto

 

7

Fig. 21

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

JUMP SEAT - 3-Point Harness

• Secure the child with the jump seat 3-point harness (Fig. 21) when child is sitting on the jump seat.

the child tray and STRAP THE SAFETY BELT

 

OVER THE CAR SEAT through the seat belt

 

slots on the infant car seat, connect the buckles

 

together. (Fig. 26) Tighten the strap so the infant

Fig. 25

 

 

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved. 8

Page 5
Image 5
Baby Trend 2.1 To Recline Seat, Platform Safety Belt, Travel System Safety Belt, Front Seat, Jump Seat 3-Point Harness