SAFETY

car seat fits snug and can't move.

IT IS VERY IMPORTANT THAT THE INFANT CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED AROUND THE INFANT CAR SEAT.

DO NOT USE INFANT CAR SEAT

WITHOUT THE SAFETY BELT.

Fig. 26

To remove infant car seat:

Unfasten the safety belt and store in pocket located on each side of seat, then squeeze the release handle located at the foot-end of the infant car seat and carefully lift upward. (Fig. 27)

Fig. 27

JUMP SEAT

SIT ON JUMP SEAT

Have the child sit on the jump seat facing backwards. Secure the child with the jump seat 3-point harness. Part of the 3-point harness is

Fig. 28stored in the pocket on the back of the front seat. Put the seat belt around the child's waist, and buckle to the crotch strap (Fig. 28). Adjust the seat belt to be snug around the child's waist.

STAND ON THE PLATFORM

Position the child on the platform on the back of the stroller. Be sure child is standing facing foward and hands are holding frame. Secure the stand feature safety belt behind child and engate buckle (Fig. 29). Be sure that the child's feet are fully on the platform at all times.

Fig. 29

CAUTION: Read the

following section completely before folding your stroller!

WARNING: Care must be taken when folding and unfolding the stroller to prevent finger entrapment.

TO FOLD STROLLER

• Close the canopy as described in the canopy section.

• Pull stroller backward several inches to rotate the front wheels to the front. (Fig. 30)

• The stroller is folded by simultaneously pulling each trigger fold. (Fig. 31) When the fold latches are released, the handle will begin to fall toward the floor. Release the fold buttons and press downward on the stroller handle until the stroller is completely folded. Secure the stroller in the folded position by hooking the fold latch, located on the right side of the stroller, over the rivet that protrudes from the frame. (Fig. 32)

SEAT PAD

To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.

OTHER

Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed.

FOLD

Fig. 30

Fig. 31

Fig. 32

9

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

10

Page 6
Image 6
Baby Trend 2.1 manual Jump Seat, To Fold Stroller, Seat PAD, Other