GB
Electrical requirements
Before inserting the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply.
•Take care to ensure that the plug remains readily accessible. Do not use multiple adapter bar or extension cable.
Warning! This appliance must be earthed.
Repairs to electrical equipment should only be performed by a qualified technician. Incorrect repairs carried out by an unqualified person carry risks that may have critical consequences for the user of the appliance.
Transportation instructions
1.The appliance should be transported only in upright position. The packing as supplied must be intact during transportation.
2.If during the course of transport the appliance, has been positioned horizontally, it must not be operated for at least 4 hours, to allow the system tosettle.
3.Failure to comply with the above instructions could result in damage to the appliance, for which the manufacturer will not be liable for.
4.The appliance must be protected against rain, moisture and other atmospheric influences.
Important!
•Care must be taken while cleaning/carrying the appliance not to touch
the bottom of the condenser metal wires at the back of the appliance, as this
could cause injury to fingers and hands.
•Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.
Instructions for use
•Make sure that the mains cable is not caught under the appliance during and
after moving, as this could damage the cable.
•Do not allow children to play with the appliance or tamper with the controls.
Installation instructions
1.Do not keep your appliance in a room where the temperature is likely to fall below 10 ° C (50 ° F) at night and/or especially in winter, as it is designed to operate in ambient temperatures between +18 and +43 ° C (50 and 90 ° F). At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food.
2.Do not place the appliance near cookers or radiators or in direct sunlight, as this will cause extra strain on the appliance's functions. If installed next to a source of heat or freezer, maintain the following minimum side clearances: From Cookers 30 mm
From Radiators 300 mm From Freezers 25 mm
3.Make sure that sufficient room is provided around the appliance to ensure free air circulation.
• Put the back airing lid to the back of your refrigerator to set the distance between the refrigerator and the wall.
4.The appliance should be positioned on a smooth surface. The two front feet can be adjusted as required.To ensure that your appliance is standing upright adjust the two front feet by turning clockwise or
5.Refer to "Cleaning and Care" section to prepare your appliance for use.
2
