Baby Trend 7581 manual To Secure Child, To Secure Rear Standing Child, To USE Jump Seat

WARNING: Avoid serious injury from falling or sliding out. Always use the seat belt.

TO SECURE CHILD

TO SECURE FRONT/REAR SITTING CHILDREN

1 The shoulder straps of the 5-point harness has 2 attachment positions. Select the loop position that places the shoulder strap level with, or below the top of the child’s shoulder and feed the shoulder harness under the correct loop. Please see figure 10.

2. Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the shoulders. Place the crotch strap and between the child’s legs. Insert the male end of each shoulder / waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders. Please see figure 11.

3. To release, apply pressure to both sides of each male clip until the clip is released. This process requires a moderate amount of effort so as to prevent an accidental release by your child. NOTE: Buckles may be hard to release when 1st used.

TO SECURE REAR STANDING CHILD

1. The rear platform and jump seat are designed to accommodate a child who is at least 2 1/2 years old, has good balance and coordination, and is not over 40 inches tall. Position the child on the platform on the back of the stroller. Be sure child is facing forward and hands are holding frame. Secure the safety belt behind child and engage buckle. See figure 12.

2. Be sure that the child’s feet are fully on the platform at all times. PLEASE NOTE: When using the rear SEAT you must put the STAND FEATURE SAFETY BELT in the storage location located on the rear of the seat. Please See Fig. 12A

WARNING: To avoid a possible choking hazzard when using the rear seat, put the STAND FEATURE SAFETY BELT in the storage location on the rear of the seat.I

TO USE JUMP SEAT

1.Have child sit on the jump seat facing backwards. Secure the seat belt, which is attached to the back of the seat, around the child’s waist, and buckle to the crotch strap. See figure 12B. Adjust the seat belt to be snug around the child’s waist.

2.To release, apply pressure to both sides of the male clip until the clip is released. This process requires a moderate amount of effort so as to prevent an accidental release by your child.

3.Be sure that the child’s feet are fully on the platform at all times.

Fig. 10.

Shoulder Strap

Waist Squeeze

Strap

	Adjust for a
Crotch Strap	snug fit
	Fig. 11.

Fig. 12.

Fig. 12A.

Fig. 12B.

5