![](/images/new-backgrounds/1129302/12930245x1.webp)
7.0INSTALLATION
1.Locate a LATCH seating position as identified in your vehicle owner’s manual. Some LATCH seating positions may require deploying of anchors, or installation of guides.
2.Remove the Safety Seat from the base by squeezing the base release handle located under the center of the foot end of the
Safety Seat and lifting upward on the Safety Seat. (Fig.
7.0INSTALLATION
place. Check that there is no slack in the webbing on both sides of the base and that the base is tightly installed. Fig.
6. Check that nothing is on top of the base or |
anything that will interfere with the proper |
latching of the Safety Seat to the Base. Place |
3.Remove the LATCH connectors from their storage position inside the base
(Fig. 44-1). Place the Base in the rear- facing position in a forward facing vehicle seat as shown in Fig. 45-1. The Child must face the rear of the vehicle and Safety Seat must be placed in a vehicle seat that faces forward.
4.Locate the LATCH anchors in the vehicle seat. (Fig. 44-2) Once located, snap the
Safety Seat LATCH connectors onto the steel rod. Listen for the click and check that both connectors are firmly attached to the anchor rods by pulling outward on the connectors. (Fig.
5.Proper installation of the Base requires that the LATCH webbing be very tight. To tighten the webbing, push down hard with your knee or hand on the Base while pulling upward on each webbing end. The webbing will automatically lock in
Fig.
Latch Anchor
Fig.
the Safety Seat onto the Base and push down |
until the Safety Seat latches securely to the |
Base and you hear a click. Pull upward on |
the Safety Seat to check that the Safety Seat |
is securely latched onto the base. (Fig. |
If the Safety Seat does not securely latch |
onto the Base, the Safety Seat will provide |
No Protection for your child. DO NOT use |
the Safety Seat with the Base if it does not |
securely latch onto the Base. Please call |
Baby Trend at |
7. To remove the base from the vehicle, |
squeeze the webbing release button |
on the LATCH connector to loosen the |
webbing. (Fig. |
that the LATCH connector can not be |
released from the LATCH anchor if the |
webbing is tight. Press the LATCH |
hook release button on each |
connector to release the connector |
from the anchor. (Fig. |
Snap onto anchors
Fig.
Fig.
Fig.
44 | 45 |