I. INSTALLATION INSTRUCTIONS
1. INSTALLATION:
(i)Installation of this broiler must conform with the latest edition of ANSI Z223.1/NFPA National Fuel Gas Code in USA (
(ii)Use this Broiler only with an adequately sized exhaust hood. The room in which this broiler is installed must be suitably vented in accordance with the National and or local codes.
(iii)In MASSACHUSETTS: All gas products must be installed by a “Massachusetts” licensed plumber or gas fitter. Ventilation hoods must be installed in accordance with
2. ACCEPTABLE CLEARANCES:
Due to intense heat generated by radiation, only
(i)Minimum Clearance From
Right | Left | Back | Floor |
0 | 0 | 0 | 4" (100 mm) |
3. GAS CONNECTION: |
|
|
|
A separate gas shut off valve (supplied with unit) must be installed in a readily accessible location in the gas line ahead of the pressure regulator (see figure “A”). The gas pressure regulator supplied must be installed on the gas inlet pipe of the broiler (see below). Each regulator is adjusted to yield a pressure of 3.5" water column (9 mbar) for Natural Gas or 10" water column (25 mbar) for Propane Gas.
All products used with combustible gas, including gas pressure controls, must be installed and used strictly in accordance with the manufacturer's instructions and all applicable government codes and regulations and plumbing practices.
Figure “A”
PRESSURE REGULATOR
MAIN |
Do not use the gas pressure regulator if it appears to have been tampered with or damaged in any way as this may affect proper operation and may create potentially dangerous conditions.
Install the regulator properly with the direction of gas flowing as indicated by the arrow on the casting. (The arrow must be pointing to the Gas Appliance).
Use a pipe compound or thread sealant that is compatible with the gas supplied to the regulator and apply it in accordance with the manufacturer's recommendation.
Apply wrench pressure only to the flat area at the threaded end of the regulator closest to the gas appliance to avoid fracturing the regulator body.
Make sure markings or paintings on the regulator are not painted over or otherwise obliterated.
Check carefully for gas leaks immediately after the regulator has been installed and the gas turned on. Do this before attempting to operate the appliance. Use a soap and water solution (or other accepted leak tester) around all pipe joints. It is a good practice to periodically check for gas leaks during use of the appliance. Do not use the appliance if a gas leak is detected.
3
