Bakers Pride Oven NMK Extraction, Electrical Connection, Safety Cut-Out - Re-Set Button

EXTRACTION

Extraction is not a specific requirement for this type of appliance.

Certain conditions e.g.

Installation in a confined space, temperature controlled environment, continuous use or high volume production cooking may require the need for ventilation or extraction.

Consult your local Ventilation/Extraction, Air conditioning company or contact the Technical Services Department at BKI.

ELECTRICAL CONNECTION

This appliance requires a 230V,50Hz single phase + Neutral + Earth power Supply.

WARNING - THIS APPLIANCE MUST BE EARTHED

•Each appliance is despatched with an electrical test certificate.

•Check the details shown on the appliance data rating plate against the cer- tificate supplied.

•Check that the voltage shown on the data plate and test certificate con- forms with your power supply.

If the details do not conform contact the Technical Services Department at BKI

BKI Europe
Theale Technology Centre
Station Road
Theale
Reading
West Berkshire
RG7 4AA
Tel: (44) 0870 990 4242
Fax: (44) 0870 990 4243	Web: www.bkideas.com
	6

Safety Cut-Out - Re-Set Button

If the safety thermal cut-out operates, first check that the oven has been installed properly and is operated and cleaned in accordance with the installation and oper- ating instructions.

•Turn the mains switch `OFF`, disconnect oven from mains power supply.

•Refer to the relevant wiring diagram and check all components and con- trols before re-setting the safety thermal cut-out.

•The safety thermal cut-out is located within the oven control panel compart- ment. Reset the thermal cut-out as follows:-

1.Remove the two side panel securing screws, slide the panel `Up` and `Out` at the bottom.

2.The safety thermal cut-out is sited towards the top left of the component plate.

3.Press hard on the `Red` re-set button on top of the thermal cut-out (allow time for the oven to cool down).

4.Replace side panel and check oven operation.

WARNING:

REPEATED OPERATION OF THE SAFETY THERMAL CUT-OUT IS A CLEAR INDICTAION OF COMPONENT FAILURE OR MISUSE.

SERIOUS DAMAGE WILL OCCUR IF THE CAUSE IS NOT IDENTIFIED AND RECTIFIED.

11