Bakers Pride Oven NMK installation manual Operating, Safety Cut-Out, Electrical Connection

OPERATING

Please read the operating instructions thoroughly and ensure all packaging has been removed before switching mains power “ON”.

IMPORTANT:

Ensure that who-ever is operating this appliance is fully conversant with its work- ing and is made aware of the dangers of incorrect operation.

If the operating manual is not available with the appliance, please contact the Technical Services Department at BKI (See page 6)

Safety Cut-Out

For added safety `NMK` rotary ovens have a built in thermal cut-out to protect against overheating through component failure or incorrect use.

If for any reason the thermal cut-out operates the oven will automatically shut down and should be switched `OFF`, disconnected from the mains and allowed to cool.

NOTE: THE THERMAL CUT- OUT WILL NOT RESET AUTOMATICALLY

The oven must not be re-used until it has been checked by a qualified electrician or BKI appointed service agent.

10

ELECTRICAL CONNECTION

•Single phase appliances fitted with a power supply cable having a rated input Not exceeding 3kW may be connected to a suitable power supply by means of a BS 1363 ASTA approved 13 amp plug fitted with a BS 1362 fuse.

•Do not use an adaptor or extension lead, plug directly into a 13 amp socket outlet.

•Check the appliance data rating plate and test certificate for appliance fuse rating.

•Where a 13 amp plug is required, please follow the instructions below:

WARNING - THIS APPLIANCE MUST BE EARTHED

IMPORTANT:

The wires in the mains lead are coloured in accordance with the following code:

GREEN & YELLOW EARTH

BLUENEUTRAL

BROWNLIVE

As the conductors in the equipment mains lead may not correspond with the coloured markings of the terminals in your plug, proceed as follows:

The wire that is coloured green & yellow must be connected to the terminal in the

plug that is marked with the letter E or by the Earth symbol or coloured green or green & yellow.

The wire that is coloured blue must be connected to the terminal that is marked with the letter N or coloured black.

The wire that is coloured brown must be connected to the terminal that is marked with the letter L or coloured red.

7