DAILY CLEANING SCHEDULE

Clean down oven after last cook of the day as follows: -

IMPORTANT: - Before the start of any cleaning operation, allow oven to cool below 50 oC, then turn the oven mains switch “OFF”, and disconnect from the power supply

•Turn any Pre-heat/ Cook/ Hold programs “OFF”, press & hold “STOP”.

•Turn oven lights & rotation switches “OFF”.

•Leave mains switch ‘On’, wait for oven temperature to drop to approx. 50 oC. (Oven fans rotate for 20 seconds & help to cool the oven).

•Remove accessories, meat-forks, baskets etc; allow to soak in a solution of hot water and Anti- bacterial detergent

•When the oven is cool (50 oC):

Switch “OFF” and disconnect from the power supply by removing the plug.

•Remove the centre shaft and rotor disc assemblies, empty the fat drawer using the drain valve or FTU ® fat pump, replace fat drawer.

•Remove Fan cover. Spray both sides of the fan cover with Oven cleaner, lay fan cover in the bottom of the oven, leave for 10 mins.

•Spray Oven cleaner onto the interior oven walls leave for 10 mins. Do Not spray the fans or elements!

•Remove the Element cover plate (4 nuts) and rinse in a Hot solution of Anti-bacterial detergent and water, scrub clean with a stiff nylon brush or scouring pad, if necessary scrape any carbon deposits from around the Air Inlet slots.

•Wash away all traces of Easy 6 with hot water and a clean cloth, down into the fat drawer, empty fat drawer and wash out with Anti-bacterial detergent.

•Clean oven glass doors; Clean glass with a dilute solution of warm water and Anti-bacterial detergent using a soft cloth.

•Rinse thoroughly with clean water and dry with tissue or paper towels, use clear liquid glass cleaner for a smear free finish.

•Allow to air dry or thoroughly dry oven interior and removable parts, before re-assembly.

•Avoid getting excess water over the control panel or ventilation slots of this oven.

REPLACE ALL PANELS BEFORE RE-CONNECTING THE ELECTRICAL SUPPLY.

15

NOTICE:

THE COMBINATION OF FACTS, DATA, DESIGN ELEMENTS, ENGINEERING DATA, MANUFACTURING DATA & ASSEMBLY DATA

WHICH MAY BE CONTAINED IN THIS DOCUMENT ARE OF A PROPRIETARY NATURE TO BKI.

THESE MATERIALS ARE NOT TO BE USED OR COPIED WITHOUT PRIOR WRITTEN PERMISSION FROM BKI.

ALL RIGHTS ARE RESERVED.