The Controls (cont).

Function Keys

Hold :

Starts the hold cycle of the program number shown in the display area.

While in the programming mode, the hold button accesses the Hold time and temperature settings.

Hold : function allows the operator to hold the product in the oven at a reduced temperature (minimum 650C maximum 800C) with a pre-set time limit.

When Hold function is activated, display will show temperature and count time up from 0:00 (Zero) to the pre-set time limit.

The “Xtra Time” button will only function if the “Hold” function has been programmed or the oven is above the hold temperature.

Prog :

Activates the Navigation keys allowing the operator to select a program number

Enters the “Programming mode” allowing the operator to create pre-sets for Programs 1 –15. (unless

the controller has been locked ! refer to section, Locking the controller, for further details)

Pre-Heat :

Starts the oven pre-heating, this function allows the operator to pre-heat the oven to the selected program first stage temperature before loading the oven with product.

While in the programming mode, the Pre-heatbutton accesses Stage-1cook time and temperature settings.

Stop :

A quick press of the Stop button ` pauses` the controller during a pre-heat or cook/hold cycle. Press and hold the Stop button to end a Pre-heat or Cook/Hold cycle.

Note: the oven fans will continue to run for 20 seconds after the end of the Cook/Hold cycle, this is normal.

7

NOTICE:

THE COMBINATION OF FACTS, DATA, DESIGN ELEMENTS, ENGINEERING DATA, MANUFACTURING DATA & ASSEMBLY DATA

WHICH MAY BE CONTAINED IN THIS DOCUMENT ARE OF A PROPRIETARY NATURE TO BKI.

THESE MATERIALS ARE NOT TO BE USED OR COPIED WITHOUT PRIOR WRITTEN PERMISSION FROM BKI.

ALL RIGHTS ARE RESERVED.