
SureCross™ DX81 FlexPower™ Supply Module
|
| Specifications | |
General |
|
| |
| Mounting | #10 or M5 (M5 hardware included) |
|
|
|
|
|
| M5 fasteners – Max. Tightening Torque | 0.56 N•m (5 in•lbf) |
|
|
|
|
|
| Case Material | Polycarbonate |
|
|
|
|
|
| Weight | 0.26 kg (0.57 lb.) |
|
|
|
|
|
| External Cable Glands | One 1/2 NPT type |
|
|
|
|
|
| Cable Glands, Max Tightening Torque | 0.56 N•m (5 in•lbf) |
|
|
|
|
|
| Connections | PVC cable; |
|
|
|
|
|
Environmental |
|
| |
| Environmental Rating* | IEC IP67; NEMA 6 |
|
|
|
|
|
| Operating Temperature** |
| |
|
|
|
|
| Operating Humidity | 95% max. relative |
|
|
|
|
|
| Radiated Immunity | 10 V/m, |
|
|
|
|
|
|
| IEC |
|
| Shock and Vibration | Shock: 30g, 11 millisecond half sine wave, 18 shocks |
|
|
| Vibration: 0.5 mm |
|
|
|
|
|
*Please refer to the SureCross™ DX80 Wireless I/O Network product manual, Banner p/n 132607, for installation and waterproofing instructions.
**Operating the devices at the maximum operating conditions for extended periods can shorten the life of the device.
Hookup Diagram
5-pin M12 Quick Disconnect Pinout
Only FlexPower™ DX80 devices may be powered from this supply.
3 | Blue | dc common (GND) |
5 | Gray | 3.6 - 5.5V dc |
Do not apply more than 5.5V dc to the gray wire.
The manufacturer does not take responsibility for the violation of any warning listed in this document.
CAUTION . . .
Make no modifications to this product.
Any modifications to this product not expressly approved by Banner Engineering could void the user’s authority to operate the product. Contact the Factory for more information.
Always use lightning arrestors/surge protection with all remote antenna systems to avoid invalidating the Banner Engineering Corp. warranty. No surge protector can absorb all lightning strikes. Do not touch the DX80 or any equipment connected to the DX80 during a thunderstorm.
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied.
All specifications published in this document are subject to change. Banner reserves the right to modify the specifications of products, prior to their order, without notice. Banner Engineering reserves the right to update or change documentation at any time. For the most recent version of any documentation, please refer to our website: www.bannerengineering.com. © 2007 Banner Engineering Corp. All rights reserved.
P/N 131596 rev. C
Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN USA 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com