Installation
15
Installation

Precautions

• Keep your original packaging. It is designed for this display and
is the ideal protection during transport.
• Avoid reflections in the flat panel to reduce eye strain.
• Place the display on a strong and stable table or desk.
• Keep the display away from heat sources and provide enough
ventilation in case it is built in a rack or console. Do not put in
direct sunlight.
• Make sure computer and display are switched off before
connecting the signals.
• Touch panel precautions: Operate with a stylus (tip R0.8 or over,
maximum hardness 3H), or with a finger without applying
excessive load. Sharp edged or hard articles are prohibited. The
gathering of dew in the panel may occur with abrupt
temperature or humidity changes. A stable environment
condition is recommended. Keep the surface clean. No
adhesives should be applied. Avoid high voltage and static
charge.

Wall mounting

You can mount the panel to the wall instead of to the foot, by means of
the supplied mounting plate. If you do not need to mount the panel to
the wall, please skip this item.
Step 1: Remove the panel from the foot
1. Position one hand under the panel at the front side. Position the
other hand at the rear, under the push-button with BARCO logo
(9).