Barco MFGD 2320 - page 11

User manual MFGD 2320 10
To connect analog video & sync signals on BNC:
Connect the video & sync output of the signal source to the video and
sync inputs (9), (8) and (7) of the display.
The inputs accept the following signals:
• Video with separate horizontal and vertical sync.
- The connection consists of 3 cables.
- Connect the video signal to the connector Video (9).
- Connect the horizontal sync signal to the connector HS/CS (8).
- Connect the vertical sync signal to the connector VS (7).
-Make sure the signal connected to the HS/CS connector
does not contain Composite sync.
• Video with external composite sync.
- The connection consists of 2 cables.
- Connect the video signal to the connector Video (9).
- Connect the composite sync signal to the connector HS/CS (8).
-Make sure no signal is connected to the VS connector.
• Video with internal composite sync (sync on video).
- The connection consists of 1 cable.
- Connect the video (with sync) signal to the connector Video (9).
Notes:
• The video inputs cannot be connected in loop-through (daisy-chain).
• The required video amplitude: 700 mV ± 3 dB.
• The required sync. amplitude:
- VS input: 700 mV to 4 V
- HS/CS input: 500 mV to 4V
- Video input (sync on video): 150 mV to 600 mV
To connect analog video & sync signals on D15:
1 Connect one end of the VGA cable to the D15 input (6) of the
display.
2 Connect the other end of the VGA cable to the video output of your
computer.
3 Route the cable so that it enters the connector compartment at the
place where the cover is bulged.
To connect the power:
1 Connect the output of the 12V DC power supply to the DC input (12)
of the display.
2 Connect one end of the proper power cable to the AC input of the
12V DC power supply.