2.4 Connecting the signals
To get access to the connectors, open the cover of the connector compartment by pulling down the 2 clips of the cover.
To connect the video & sync signals:
1Connect one end of the video cable to the DVI input (5) of the display.
2Connect the other end of the video cable to the video output of your video source (Computer graphics board with digital video output).
3Route the cable so that it enters the connector compartment at the place where the cover is bulged.
Vid1 |
Vid2 |
Example of signal connection in a Coronis dual- head system
To connect the power:
1Connect the output of the 12V DC power supply to the DC input (6) of the display.
2Connect one end of the proper power cable to the AC input of the 12V DC power supply.
MFGD 3220D User's Guide | 12 |
