6. Setup
Followingmessage is displayed: “Connected to <projectorname>...”
How to select an existing projector byits name ?1. Click on the three suspension points to open the projector selection dialog box, image 6-44
2. Open the listbox and select the projector.
Image6-46
the locationwill also be filled (if it has been entered previously).
3. Click on Connect.
Followingmessage is displayed: “Connected to <projectorname>...”
How to select an existing projectorby its location ?Can be useful when the projector name is not known.
1. Click on the three suspension points to open the projector selection dialog box, image 6-44
2. Open the listbox and select the location.
Image6-47
The projector name is filled in.
3. Click on Connect.
Followingmessage is displayed: “Connected to <projectorname>...”
Thisis only p ossible if the location has been filled, the default value for location being “<New Location>”
Ifthe projector is notfound fo llowing message will be displayed : “Host not found”
Ifthe projector is found but unable to respond (projector disconnected from the network, server software not
running, ...) following message will be displayed : “Host found , butserver inactive”
R5976992 ICON H250/400 13/12/2006 53