POWER CONNECTIONS MGA11500H

ENGLISH

1

CHIL

+12V TURN-ON GND

MIN

 

 

MANDATORY IN-LINE POWER FUSES

(200A)EACH MOUNTED WITHIN 6" FROM AMPLIFIER

(PROVIDED)

MANDATORY IN-LINE POWER FUSES

(200A)EACH MOUNTED WITHIN

6" FROM BATTERY

(NOT PROVIDED)

94.7

RADIO'S REMOTE TURN-ON OUTPUT

+-

CAR BATTERY

+12V

IMPORTANT! The amplifier is NOT fused internally. You MUST fuse the power line at the

amplifier and at the battery. Failure to do so could cause serious damage to the amplifier as well as the vehicle. Before making any connections, disconnect the car’s battery until the installation is completed to avoid possible damage to the electrical system.

Connect the amplifier to the car's battery

Because of the extremely high current draw of MGAH11500 we recommended professional installation of this amplifier. If you decide to install yourself, please make sure to properly fuse the amplifier.

Make your power connections using a 4 gauge power wire for your connections. Strip one end of the wire to connect to the terminal on the amplifier marked “+12V”. Loosen screw terminal and connect bare wire and tighten. Use caution to make sure no stray wire strands come in contact with surrounding terminals causing short circuits. Connect an in- line fuse(200A) within 6” of the amplifier and then run the wire directly to the positive terminal of the car's battery. Make sure to use an in-line fuse(200A) within 6” of the car's battery to protect the electrical system and amplifier against short circuits and/or power surges.

Connect the ground terminal of the amplifier to the car's chassis

For the ground connection, use a 4 gauge wire (black) to connect to the terminal marked “ground” and then connect it to the car's chassis. Try to keep the length of the cable as short as possible, preferably less than 6". Also make sure that the point on the car where the connection is to be made is free of paint and dirt.

Connect the remote terminal of the amplifier to a switchable +12V source

This connection allows the amplifier to be turned on and off with the power control of the radio. If the radio has a REMOTE output terminal, connect it to the amplifier's terminal marked “TURN-ON” (using a 16 gauge wire or heavier). Now when the radio is turned on, the amplifier will automatically turn on.

9

Page 10
Image 10
Bazooka MGA11000H manual Power Connections MGA11500H, Connect the amplifier to the cars battery