BEA 10 Programming Guide, Number Keys, Unlock Inquire ? Lock, Adjustment Keys, Default Values

6 Programming Guide

The Eagle is equipped with a Motion Tracking Feature (MTF). The MTF is available when the Eagle is used in the uni- directional mode. The Eagle is factory preset with the MTF ON. MTF is recommended for use in short vestibule areas to help reduce unwanted door hold-open time. Refer to the Programming Guide to alter this setting. BEA recommends keeping the MTF enabled for all applications. The detection capabilities perform as follows:

BI-DIRECTIONAL MODE:

•Detection of all motion towards or away from the sensor.

UNI-DIRECTIONAL MODE:

•The detector will work in a uni-directional mode at all times regardless of traffic patterns - detecting only motion moving toward the sensor.

OR

UNI-DIRECTIONAL MODE WITH MTF: The principle is as follows:

•The detector does NOT activate its relay as long as it detects movement exclusively moving away from the detector. It acts like the classic unidirectional detector.

•As soon as the Eagle detects movement toward the sensor, it automatically switches to bi-directional mode.

•The Eagle maintains the bi-directional function for approximately 2 seconds following the last detection of motion toward the door.

•At the end of the 2-second time frame, if the Eagle does not detect any further motion, it switches back to the unidirectional mode.

Number Keys

Number keys (0 through 9) are used for assigning a value for a given function

Unlock

Inquire ?

Lock

To UNLOCK the sensor:

Press the UNLOCK key once. Red LED flashes quickly

To LOCK the sensor:

Press the LOCK key twice, OR press once then followed by a 4-digit lock code. If less than 4 digits, press lock again after the last digit. LED goes out when complete.

To INQUIRE the sensor:

Unlock the sensor, press the desired function key, followed by the INQUIRY key – the number of green flashes corresponds to the value.

Default: 0000

Adjustment Keys

Plus (+) and minus (-) keys are used for incremental adjustments to the sensor

Relay Configuration

The relay configuration has 4 possible output values:

1= Normally Open Relay

2= Normally Closed Relay

3=Continuous Detection

4=Continuous Non-Detection

Default: 1

Default Values

After pressing the DEFAULT VALUE key, the red LED flashes quickly. After pressing a number button, the red LED flashes slowly.

1 = Normal Mounting Height (only for serial numbers lower than 84000)

2 = Boost Mode, increases sensitivity for high mount applications.

9 = Restore default values except lock code (for serial number 84000 and greater)

75.5185.04 20070727 Page 6 of 8