SAFETY PRECAUTIONS
•Shut off all power going to the header before attempting any wiring procedures.
•Maintain a clean & safe environment when working in public areas.
•Constantly be aware of pedestrian traffic around the door area.
•Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions by the door.
•Always check placement of all wiring and components before powering up to insure that moving door parts will not catch any wires and cause damage to equipment.
•Ensure compliance with all applicable safety standards upon completion of installation
MECHANICAL
INSTALLATION -
OPENING THE
SENSOR
From behind, before installation | From the front, after installation |
MECHANICAL
INSTALLATION -
PREPARATION
FOR MOUNTING
THE SENSOR
Paste the template at desired location. Drill as instructed.
Insert screws but do not screw them fully in.
If possible, pass the cable where it is supposed to go through.
If you don't want to drill your profile for the cable, you can cut the wire opening footprint as shown in the picture.
ELECTRICAL INSTALLATION - CABLING & CONNECTION
Run the cable through the wire passage hole just below PCB.
Position the sensor and tighten the two screws. Make sure you leave enough cable to reach the terminal block.
12-24 V AC/DC COM NO NC
75.1038 V3 Jun 2005 [Rev. June 10, 2005] | Page 2 of 8 |
