BEA Eagle HM Programming, User’S Actions, Default, Led Status, GUIDE Cont, Manual Set-Up, Trouble

PROGRAMMING			KEY	USER’S ACTIONS			DEFAULT	LED STATUS
GUIDE Cont.		DETECTION MODE		Detection mode offers 3 different levels of			3	After pressing the DETECTION MODE
				detection: Bi-directional, Uni-directional and				key, the red LED flashes quickly. After
				Uni-directional with MTF (motion tracking				pressing a number button, the red LED
				feature). MTF allows the Eagle to switch				flashes slowly.
				from uni-directional to bi-directional upon
				detection from the normal approach
				direction.
					1	= Bi-directional
					2	= Uni-directional
					3	= Uni-directional with MTF
		IMMUNITY		Immunity alters the detection of unwanted			2	After pressing the IMMUNITY key, the
				disturbances within the field of motion				red LED flashes quickly. After pressing
				detection.				a number button, the red LED flashes
					1	= Extreme sensitivity		slowly.
					2	= Normal Sensitivity
					3	= Reduced sensitivity
	DEFAULT VALUE				1 = Restores default values for all			After pressing the DEFAULT VALUE
								key, the red LED flashes quickly. After
					functions			pressing a number button, the red LED
					2 = Boost Mode; Restores default			flashes slowly.
					values for all functions, and increases
					sensitivity for high-mount applications.
MANUAL SET-UP		If a remote control is not available, you can adjust the sensitivity parameter ONLY, by means of the push
		buttons + (Plus) and - (Minus).

The sensor parameters that are not accessible manually will remain at the factory preset values. Pressing the two push buttons, located on the circuit board, simultaneously for at least two seconds, will restore all default values.

+ Press to increase sensitivity by one unit

- Press to decrease sensitivity by one unit.

TROUBLE-
	The door will not open & LED does not	1.	Check supply voltage: 12 to 24 VAC: ± 10%
SHOOTING	light up		12 to 24 VDC: -10% / +30%
		2.	Check power connector
	The sensor does not respond to the	1.	Check remote control battery insertion
	remote control	2.	Check remote control battery voltage
	The sensor does not respond to the code	1.	Remove the cover and press the 2 buttons
	entered with the remote control		simultaneously for at least two seconds. This will reset
			the lock code to 0000. Then press the unlock button to
			enable you to access the settings with the remote control.
	The door open and closes constantly	1.	Increase the tilt angle of the antenna
		2.	Reduce sensitivity

75.1038 V3 Jun 2005 [Rev. June 10, 2005] Page 7 of 8